Rate this post

According to current technical reports, many users are experiencing the Canon printer error B200 problem. The problem is usually caused by problematic cartridges, dirty or damaged printheads, or problems in the tank holder.

canon printer customer care
Canon Printer Error B200

However, some unknown obstructions can also cause this problem. These are some of the main reasons, other issues can be added to this list. So, you should fix the problem as soon as possible so that further problems can be avoided.

Read:- How to Fix Canon Printer Error E32

Here we are going to discuss the most recommended solutions that can help you.

5 Way to Fix Canon Printer Error B200 Code

The only way to resolve the Canon B200 printer error is to follow these best possible solutions which are given below. Follow them carefully and apply them in the exact order listed.

Solution 1: Reset the Ink Cartridges and Print Heads

Print as well as ink cartridges also have a higher probability of resolving the error of your Canon printer. The steps to be taken are shown below:

  • Open the top cover of the device and you will be able to see that the cradle will appear. Because Canon printers have more than one cartridge, remove them all at once.
  • Now lift the lever inside the cradle and slowly remove the printhead.
  • Wait a few minutes, then reinsert the printhead into the printer. Make sure that you have closed the outlet safely.
  • After that, re-install all the ink cartridges into their own slots and close the door as well as the top cover.

Now make sure the printer is ready and can access the cartridge as well as the printhead. Unplug the printer from the power outlet and leave it idle for about 5 minutes.

After that, plug in the printer and turn it on. Try printing the page and check if there is no error. If the situation remains the same, move on to the next solution.

Solution 2: Replace problematic cartridges

As you may already know that the Canon B200 printer error occurs due to the presence of defective cartridges, it would be better to remove the cartridge. Also, replace them with a new one.

We hope you have a printer user manual. Check where you can find the simple procedure to replace the cartridge. After replacing the old one, try printing and check if the problem persists.

Dirty printheads are one reason that can cause errors in your Canon printer. So the only solution is to open the printhead and clean it. Follow the instructions above to open the printer print.

Solution 3: Clean the Print heads

In addition to these instructions, we strongly recommend you to consult the user manual. Clean the printhead with a fine lint-free cloth moistened with alcohol. After that, allow it to dry completely before putting it back in the printer.

Solution 4: Remove any Physical Obstructions 

Sometimes there may be other locks inside the printer which can cause this error. To solve the problem, turn off your device, open the printer, and check if any paper or other type of material is jammed inside. If yes, remove it, turn on the printer, and try to print a document.

Solution 5: Change the Ink Tank Holder

Sometimes you can fix the problem just by replacing the ink tank holder. Open the old tank support and replace it with a new one. Again, try printing a document and note whether the problem persists or not.

In addition, you can press the “Feed” and “Copy” buttons simultaneously. After performing this step, check the nozzle, alignment, and perform a deep cleaning process. Hope these instructions help you to solve B200 error.

Tagged With: